www.scheppach.com
32
|
GB
1. Hold a collection container under the hose of the
petrol extraction pump (not included in the scope
of delivery).
2. Unscrew and remove the tank cover (2).
3. Remove the fuel lter insert (22).
4. Push the hose of the petrol suction pump into the
fuel tank and drain the petrol completely using the
petrol suction pump.
5. Reinsert the fuel lter insert (22).
6. Retighten the tank cover (2).
12. Transport
1. Empty the fuel tank using a petrol extraction pump
(see section 12.2).
2. If operational, keep the engine running until the
remaining petrol has been used up.
3. Drain the engine oil from the warm engine (as de-
scribed under 11.2.2 Oil change).
4. Remove the spark plug connector (21) from the
spark plug (20).
5. Secure the device against slipping using a tension
strap, for example.
6. The power generator can be lifted and moved via
the handle (1).
13. Disposal and recycling
Notes for packaging
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of sepa-
rately!
• Used batteries or rechargeable batteries that are not
installed permanently in the old appliance must be
removed non-destructively before disposal. Their
disposal is regulated by the battery law.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
Please provide the following information in the
event of any enquiries:
• Data of machine type plate
• Data of motor type plate
Important note in the case of repairs:
When returning the device for repair, please ensure for
safety reasons that it is free of oil and fuel when it is
sent to the service centre.
10.8 Ordering spare parts
Please provide the following information when order-
ing replacement parts:
• Device type
• Device article number
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
Wearing parts*: Spark plug, air lter
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
11. Storage
11.1 Preparation for storage
1. Empty the fuel tank using a petrol extraction pump
(see section 12.2).
Warning: Do not remove the petrol in enclosed
spaces, near re or when smoking. Petrol fumes
can cause explosions and re.
2. Change the oil at the end of every season.
3. To do so, remove the used engine oil from a warm
engine and rell with fresh oil.
4. Remove the spark plug (20). (Fig.12)
5. Fill the cylinder with approx. 20 ml of oil from an
oil can.
6. Pull the start pull cord slowly so that the oil pro-
tects the inside of the cylinder.
7. Screw the spark plug (20) back in.
8. Store the device in a well-ventilated place or area.
11.2 Drain petrol with a petrol extraction pump
(Fig. 13)
In case of storage over a longer period of time, the pet-
rol must be drained.
To Next Page
Loading...
Need help?
General
