www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
tion damage.
Check the electrical connection cables for damage
Ensure that the connection cables are dis
connected from electrical power when checking for
damage.
applicable VDE and DIN provisions.
AC motor
•
• Extension leads up to 25 m long must have a
2
.
The mains power connection must be protected with
•
ments.
connection points is not permitted.
•
tions in unfavourable mains conditions.
•
points that
max
”, or
•
plier in this regard.
Connections and repair work on the electrical equip
Please provide the following information in the event
•
•
•
12. Maintenance
If specialists for unusual maintenance work or
repairs must be involved, please always contact
a service point recommended by us or contact
us directly.
•
work as well as the correction of malfunctions with
•
completed.
Cleaning
m Attention! Pull out the mains plug.
• Clean the machine after work is complete.
• Dust and contamination must be removed from the
• Keep protective devices, air vents and the motor
housing free from dust and dirt.
• Clean the device clean with a clean cloth or blow
•
•
could attack the plastic parts of the device.
sure that no water can penetrate the device inte
rior.
Carbon brushes
If excessive sparks are generated, have an electri
cian check the carbon brushes.
Attention!
Check the oil level
device.
facing down. The oil level must be at the cross mark
ing.
Oil change: Fig.5
hours.
rable.
m Attention! Switch o the device. Pull out the
mains plug!
2.
container.
Attention: The used oil must be disposed of at
the appropriate waste oil collection point!
3.
To Next Page
Loading...
Need help?
General
