www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
20
|
GB
•
•
-
hose.
• The work area must be separated from the com-
pressor so that it cannot come into direct contact
with the working medium.
Operating pressure vessels
• -
-
precautions.
•
control measures in individual cases.
• A pressure vessel is not allowed to be used if it
-
ers or third parties.
• Check the pressure vessel for signs of rust and
damage each time before using. Do not use the
-
-
tact the customer service workshop.
Do not lose these safety instructions
6. Technical data
Mains connection 230 V / 50 Hz
Motor rating 2200 W
Operating mode S1
Compressor speed 2850 min
-1
100
Operating pressure approx. 8 bar
approx. 412
approx. 157
l/min
approx. 215
l/min
approx. 294
l/min
IP20
Weight of the unit in kg approx. 52
Oil (15W 40) l approx. 0,25
Max. altitude
(above mean sea level)
1000 m
Noise data
The noise emission values were measured in ac-
cordance with EN ISO 3744.
Wear hearing protection.
m Warning:
health. If the machine noise exceeds 85 dB (A),
please wear suitable hearing protection.
Sound power level L
wA
97 dB(A)
Sound pressure level L
pA
71 dB(A)
K
wA/pA
2,03 dB(A)
7. Before starting the equipment
•
are identical to the mains data.
• Prior to initial commissioning, remove the trans-
described in item 8.4.
•
-
deliver the compressor.
• Install the compressor near the point of consump-
tion.
•
cables).
•
• Do not install the compressor in a damp or wet
room.
•
rooms (with good ventilation and an ambient tem-
perature from +5 °C to 40 °C). There must be no
-
ble gases in the room.
•
rooms. It is prohibited to use the compressor in
• The oil level in the compressor pump has to be
checked before putting the equipment into opera-
tion.
•
•
not be left outdoors after work is complete.
8. Attachment and operation
m Important!
installation:
• 2 x open-ended wrench size 19 mm (not included)
• 2 x open-ended wrench size 14 mm (not included)
To Next Page
Loading...
Need help?
General
