www.scheppach.com
GB
|
17
• Attach the housing to the side coverings using at-
head screws M5 x 20 and screw nuts. Securely tight-
en all nuts. g. 6
• Slide the clamping strip through the loops on the l-
ter bag and x the lter bag on the container. g. 7
• Position the support bar into the housing and hang
the lter bag from it. g. 1
• Attach the sawdust bag to the lower air ventilator us-
ing the clamping strip. g. 7
• Attach the extraction hose to the nozzle on the hous-
ing and ax it with a hose clamp. g. 8
• Attach the hose coupling to the other end of the hose
using a hose clamp. g. 9
The extraction system should be cleaned every time
the sawdust bag is changed.
Damaged lters and bags must be immediately
changed in order to keep the amount of dust that es-
capes into the work environment as low as possible.
8. Commissioning
Attention!
Always make sure the device is fully assembled
before commissioning!
Observe the safety instructions before the commis-
sioning. The data on the motor type plate (voltage and
frequency) must match the mains voltage and frequen-
cy.
After connecting to the mains, the extraction system is
ready for operation.
9. Maintenance
For all maintenance and cleaning work, turn o the mo-
tor and pull out the mains plug.
• Installation, repairs and maintenance work on the
electrical equipment may only be carried out by
electricians.
• For constant performance, periodically shake out
lter bag vigorously. Between cleanings, beating the
bag with the hand several times is sucient.
• The sawdust bag must be replaced at the latest
when the sawdust is within 10 cm of the housing
collar.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Pressure dierence 1600 Pa
Filter area of lter bag approx. 1 m
2
Sawdust bag volume 75 l
Engine output
Electric motor 230 V/50 Hz
Rated input P1 0.55 kW
Power output P2 0.34 kW
Motor speed 2850 1/min
Workplace emission values
No-load noise 75.5 dB (A)
Operating noise 75.5 dB (A)
6. Before commissioning
• After unpacking check all parts for transport dam-
age. In the event of complaints the carrier must be
informed immediately. Later claims will not be rec-
ognised.
• Check whether the shipment is complete.
• Familiarise yourself with the product by means of
the operating instructions before using for the rst
time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Replace-
ment parts can be obtained from your scheppach
dealer.
• When ordering please provide our article number
as well as type and year of manufacture for your
equipment.
m Attention!
The device and the packaging material are not chil-
dren‘s toys! Do not let children play with plastic
bags, lms or small parts! There is a danger of
choking or suocating!
7. Assembly
For packaging reasons, your machine is not completely
assembled.
• Attach the side covering loosely to the base frame
using at-head screws M8 x 40 mm and screw nuts.
Do not tighten completely. g. 2, 3
• Attach the cross member to the side covering left
and right with at-head screws M 8 x 12 and screw
nuts. g. 4, 5
• Remove all screws and nuts from the housing.
To Next Page
Loading...
Need help?
General
