www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
24
|
GB
•
• Kinks where the connection cable has been im-
• Places where the connection cables have been cut
due to being driven over.
•
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insula-
tion damage.
Check the electrical connection cables for damage
Make sure that the connection cable does not hang
-
nection cables with the marking „H07RN-F“.
-
AC motor
•
•
cross section of 1.5 mm², and over 25 m long must
have a cross section of 2.5 mm².
•
•
•
10. Maintenance
INJURY WARNING!
Before working on the device, disconnect the
mains cable from the socket.
Always wear protective gloves when working on
or around cutting tools.
•
•
can work with the device.
• Clean the blades with a soft brush after working
-
tective oil on the whole blade.
• -
ing free and clean.
•
-
afterwards.
•
Adjusting the telescopic tube (Fig. 5)
Disconnect the tool from the electricity supply
rst!
•
•
length.
•
again, so that the length adjustment is secure.
Adjusting the motor head (Fig. 6)
Disconnect the tool from the electricity supply
rst!
Angle adjustment A
•
-
Make sure that the adjustment buttons return to their
will not start.
-
vere injuries.
8. Working instructions
NOTICES AND TIPS FOR HEDGE TRIMMER
•
hands and turn it on.
• Cut the hedge from both sides and start at the bot-
-
ing into the area that still needs to be cut.
•
hedge.
•
•
•
-
fore cutting the hedge with the device.
9. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions.
The customer‘s mains connection as well as
the extension cable used must also comply with
these regulations.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
To Next Page
Loading...
Need help?
General
