05 06
6 First Ride
5 Charging
Charge port
Open the rubber cap
Insert the plug
into the socket
Do not connect the charger if the charge port or charge cable is wet.
The battery pack is only to be charged by adults.
Your miniLITE is fully charged when the LED on the charger changes from red (charging) to green
(trickle charge). Close the rubber cap when not charging.
4 Assembling Your Segway miniLITE
1
2 3
1. Slide the steering bar onto to the mounting bracket.
2. Install the two M5 screws. Tighten securely with the included hex wrench.
3. Press the rubber cap onto the steering bar until it snaps in place.
There are safety risks when learning to ride the miniLITE. You must read the
Safety Instructions and follow the New Rider Tutorial in the App before your first
ride.
For your safety, your miniLITE is not activated at this time and will beep
occasionally after Power ON.
Until activated, the miniLITE maintains a very low riding speed and steering
sensitivity, and should not be ridden. Install the App on your mobile device (with
Bluetooth 4.0 or above), connect to the miniLITE with Bluetooth, and follow the
App instructions to activate your miniLITE and follow the training procedures.
Scan the QR code to download the App (iOS 8.0 or above, Android™ 4.3 or
above).
1
Install the App and register/login.
2
Power ON the miniLITE.
3
Click “Vehicle”→“Search device” to connect.
Your miniLITE will beep once when the
bluetooth connection is successful.
To Next Page
Loading...
Need help?
General