Shark APEX DuoClean AZ1000 Series User Manual

sharkclean.comsharkclean.com
EMPTYING THE DUST CUP
To remove Dust Cup, press release button on
top of the pod. Tilt dust cup away from wand,
then lift to remove.
To reinstall, place bottom of dust cup into
pod and then tilt back until it clicks into place.
To empty debris into trash, press lower release
button and bottom of dust cup will drop open.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush lint screen to clean.
CLEAN HEPA FILTER
EVERY YEAR
Press button at bottom of Filter Door. Tilt
door and lift out to remove, then take out
HEPA Filter.
To reinstall, insert HEPA filter into unit and
replace filter door.
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.
Regularly rinse and replace the filters to maintain your vacuum’s suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electric parts.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
Filter
Door
Filter Access
NOTE: The pre-motor filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.

Shark APEX DuoClean AZ1000 Series Specifications

General

Style	upright vacuums
Color	sage, gray
Floor Type	all floors
Dust Bin Capacity	0.22 gallons
Cord Length	30 feet
Filter	hepa
Pet Mode	yes
Hypoallergenic	yes
Brush Roll Shut-Off	no
Bagless	yes
?leaning Area	11 inches
Brushes and Accessories	crevice tool, upholstery tool
Voltage	120 volts
Current	11.3 amperes

Weight and Dimensions

Length	11.2 inches
Height	46 inches
Width	12.2 inches
Net Weight	16 pounds