[ TV Set (Bottom) ]
Power indicator
POWER
Turn on the power
• When the power indicator is off, press
POWER
.
• When the power indicator lights up dimly, press on the remote control.
The power indicator changes to bright and a picture appears.
On-screen display language selection
Remote Control
• Press
LANGUAGE
to select desired language.
• Pressing
LANGUAGE
changes the language as shown below.
TV set
• Press
MENU/PRESET
for more than two seconds, the language
select mode appears.
• Press
CH
/
CH
to select desired language.
• Pressing
MENU/PRESET
changes the screen as shown below.
• Press
MENU/PRESET
until normal screen appears.
! Adjust volume using / .
• The volume bar disappears approximately three
seconds after the volume has been adjusted.
! Using
CH
/
CH
• Press
CH
and channels change as shown below.
1 / 2 / ... / 98 / 99 / AV1 (or COMPONENT) / AV2 / 0 / 1 / 2 ...
• Press
CH
and channels change as shown below.
1 / 0 / AV2 / AV1 (or COMPONENT) / 99 / 98 / ... / 2 / 1 / 0 ...
@ With the number buttons (on remote control)
• To select a one-digit channel, such as 5, press
5
.
If “5-” is indicated, press to select one-digit
input, and then press
5
again.
• To select a two-digit channel, such as 15, press
to select the two-digit input. Press
1
, and
then press
5
.
[ Behind the door ]
Channel selection
Adjusting volume
• When the power indicator lights up dimly, either
CH
/
CH
on the TV can be pressed to turn on the power.
• Channels that have been skipped cannot be selected by
CH
/
CH
.
• The AV1 (or COMPONENT), AV2 input channels cannot be selected using
CH
/
CH
on the remote control.
Use
TV/VIDEO
to select these channels.
E6 BASIC OPERATION
Language MANUAL
Normal screen
AUTO
ENGLISH
ENGLISH
FRANÇAIS
BAHASA MELAYU
MENU/PRESET
CH
CH
LANGUAGE
TV/VIDEO
SURROUND
CH
CH
NORMAL
TV/TEXT
1 23
4 5 6
78
0
9
MENU
BACD
MPX
1
5
CH
CH
LANGUAGE
--
1-
15
PAL
B/G
VOLUME 10
ENGLISH
BAHASA MELAYU
FRANÇAIS
21K-FD3SA(05-08)EN 14/11/05, 9:52 AM6
To Next Page
Loading...
Need help?
General
