EasyManuals Logo
Home>Sharp>Microwave Oven>Carousel R-1214

Sharp Carousel R-1214 User Manual

Sharp Carousel R-1214
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
Open the bottom of thecarton, bend the carton aps back and tilt the oven over
to rest on plastic foam pad. Lift carton off oven and remove all packing materials,
WALL and TOP CABINET TEMPLATE, Turntable, and Turntable Support. SAVE THE
CARTON AS IT MAY MAKE INSTALLATION EASIER.
1. Remove the feature sticker from the outside of the door, if there is one.
2. DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the right side
wall of the oven cavity. Check to see that there is a WALL TEMPLATE and TOP
CABINET TEMPLATE. Read enclosures and SAVE the Operation Manual.
Check the oven for any damage, such as misaligned or bent door, damaged door
seals and sealing surfaces, broken or loose door hinges and latches and dents inside the cavity or on the door.
If there is any damage, do not operate the oven and contact your dealer or SHARP AUTHORIZED SERVICER.
UNPACKING AND INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
Please read all instructions thoroughly before installing the Over the Counter Microwave Oven. Two
people are recommended to install this product.
If a new electrical outlet is required, its installation should be completed by a qualified electrician
before the Microwave Oven is installed. See 3 ELECTRICAL GROUNDING INSTRUCTIONS on page 7.
1 MOUNTING SPACE
This Microwave Oven requires a mounting
space on a wall as shown in Figure 1. It is
designed to be used under standard 24-inch
wide wall cabinets.
2 WALL CONSTRUCTION
ThisMicrowaveOvenshouldbemountedagainstandsupportedbyaatverticalwall.Thewallmustbeatfor
properinstallation.Ifthewallisnotat,usespacerstollinthegaps.Wallconstructionshouldbeaminimumof
2” x 4” wood studding and 3/8” or more thick dry wall or plaster/lath. The mounting surfaces must be capable of
supporting weight of 110 pounds—the oven and contents—AND the weight of all items which would normally be
stored in the top cabinet above the unit.
The unit should be attached to a minimum of one 2” x 4” wall stud.
Tondthelocationofthestuds,oneofthefollowingmethodsmaybeused:
A. Useastudnder,amagneticdevicewhichlocatesthenailsinthestud.
B. Useahammertotaplightlyacrossthemountingsurfacetondasolidsound.Thiswillindicatestudlocation.
Thecenterofthestudcanbelocatedbyprobingthewallwithasmallnailtondtheedgesofthestudandthen
placing a mark halfway between the edges. The center of any adjacent studs will normally be 16” or 24” to either
side of this mark.
Figure 1
UNPACKING AND EXAMINING YOUR OVEN
24"

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sharp Carousel R-1214 and is the answer not in the manual?

Sharp Carousel R-1214 Specifications

General IconGeneral
Styleover-the-range
Colorstainless steel
Total Capacity1.5 cubic feet
Sensor Cookingyes
Child Lockyes
Timeryes
Microwave Power1100 watts
Current13 amperes
Weight and Dimensions IconWeight and Dimensions
Depth15.56 inches
Height14.06 inches
Width23.88 inches
Net Weight55 pounds

Related product manuals