Sharp HT-SB30D User Manual

E-3
IMPORTANT SAFETY
INSTRUCTIONS (continued)
21) Wall or ceiling mounting - When mounting the
product on a wall or ceiling, be sure to install the
product according to the method recommended
by the manufacturer.
22) Power Lines - An outside antenna system should
not be located in the vicinity of overhead power
lines or other electric light or power circuits, or
where it can fall into such power lines or circuits.
When installing an outside antenna system, ex
-
treme care should be taken to keep from touch-
ing such power lines or circuits as contact with
them might be fatal.
23) Protective Attachment Plug - The product is
equipped with an attachment plug having over
-
load protection. This is a safety feature. See
Instruction Manual for replacement or resetting
of protective device. If replacement of the plug
is required, be sure the service technician has
used a replacement plug specied by the manu
-
facturer that has the same overload protection as
the original plug.
24) Stand - Do not place the product on an unstable
cart, stand, tripod or table. Placing the product on
an unstable base can cause the product to fall,
resulting in serious personal injuries as well as
damage to the product. Use only a cart, stand,
tripod, bracket or table recommended by the
manufacturer or sold with the product. When
mounting the product on a wall, be sure to fol
-
low the manufacturer’s instructions. Use only the
mounting hardware recommended by the manu
-
facturer.
Precautions
■ General
● Please ensure that the equipment is positioned in
a well-ventilated area and ensure that there is at
least 4” (10 cm) of free space along the sides and
top of the equipment.
4” (10 cm)
SOUND BAR HOME THEATER SYSTEM HT-SB30D
4” (10 cm)
4” (10 cm)
● Use the unit on a rm, level surface free from
vibration.
● Keep the unit away from direct sunlight, strong
magnetic elds, excessive dust, humidity and
electronic/electrical equipment (home computers,
facsimiles, etc.) which generate electrical noise.
● Do not place anything on top of the unit.
● Do not expose the unit to moisture, to tempera-
tures higher than 140°F (60°C) or to extremely
low temperatures.
● If your system does not work properly, disconnect
the AC power cord from the AC outlet and replug.
● In case of an electrical storm, unplug the unit for
safety.
● Hold the AC power plug by the head when remov-
ing it from the AC outlet, as pulling the cord can
damage internal wires.
● The AC power plug is used as a disconnect de-
vice and shall always remain readily operable.
● Do not remove the outer cover, as this may
result in electric shock. Refer internal service
to your local SHARP service facility.
● This unit should only be used within the range of
41°F - 95°F (5°C - 35°C).
● SHARP is not responsible for damage due to
improper use. Refer all servicing to a SHARP
authorised service center.
Warning:
● The supplied AC/DC adaptor contains no user
serviceable parts. Never remove covers unless
qualied to do so. It contains dangerous voltages,
always remove mains plug from the main outlet
socket before any service operation or when not
in use for a long period.
● The AC/DC adaptor supplied with the HT-SB30D
must not be used with other equipment.

Sharp HT-SB30D Specifications

General

Brand	Sharp
Model	HT-SB30D
Category	Speaker System
Language	English