47
5. SERVICE MENU
MSD6486 Factory Menu Specication
How to Enter Factory Menu?
Press the RC buttons in this sequence: “Menu 1 1 4 7” to enter the factory menu.
Description:
5.1 SHIPPING INIT
5.2 BURNNG MODE
5.3 ADC ADJUST
5.4 PICTURE SETTING
5.5 SOUND SETTING
5.6 GENERAL SETTING
5.7 DEBUG
5.8 PANEL SETTING
5.9 EMC SETTING
5.10 SW INFORMATION
5.11 BOARD INIT
5.12 SW UPGRADE
5.13 OTA SETTING
FACTORY SETTING
SHIPPING INIT: TV Initilization and all parameter
to be default. Designed for Shipment.
BURNING MODE: For test panel. If it’s in
operation, use key board “power” to quit.
ADC ADJUST: Change ADC parameters
PICTURE SETTING: Change Picture Setting
SOUND SETTING: Change Sound Setting
GENERAL SETTING: Some other settings
usualy used, and also for Debug
DEBUG: Debug mode.
PANEL SETTING: Change panel parameters
EMC SETTING: Some settings may aect EMC
SW INFORMATION: Display some system information.
BOARD INIT: Initialize TV, restore to factory conguration.
SW UPGRADE: Software update item.
OAD SETTING
Board Type: Display board type
Build Time: Display Firmware build time
HDCP Check: HDCP key status
MAC Address: MAC Address
5.1 SHIPPING INIT
TV Initilization and all parameter to be default, Designed for Shipment.
5.2 Burning Mode
For test panel. If it’s in operation, use key board “power” to quit.
Picture 1 Factory setting
To Next Page
Loading...
Need help?
General