Sharp LC-52LE920UN User Manual

LC-52LE920UN/LC-60LE920UN
iv) Peel the protective sheet of the OCA.
Lift the ITO section, then peel the protective sheet by about haif by means of the pull tap.
— * Peeling it completely reduces workability.
Check the order due to workability.
v) Contact the FPCB and joint end of the transparent electrode film with the glass.
* Grasp the opposite end. Note that the ITO is positioned by adhering.
oo *Note: Do not bend the PWB (FPCB section)
Adhere first and sheet (ITO section).
vi) Adhere the transparent electrode completely.
Pull tap for peeling the front protective sheet
Peel the front protective sheet.
If bubbles are found, press those portions with glass
cleaning cloth, etc. to remove them as much as possible.
« Use a rubber roller since pressure exerted by it removes bubbles easily. See photo below.
« For the TOUCH SENSOR Unit positioning figure, see page 5-1, 5-2, 5-3, 5-4.
4-15

Sharp LC-52LE920UN Specifications

General

Brand	Sharp
Model	LC-52LE920UN
Category	TV
Language	English