Sharp LC-52LE920UN User Manual

LC-52LE920UN/LC-60LE920UN
11. Factory setting
After completing the factory setting, pull out the AC cord to complete the setting.
CAUTION: Do not turn on the power after completing the factory setting. If the power is turned on, configure the factory setting again.
Adjustment point Adjustment conditions Adjustment procedure
1 | Factory setting Complete the setting by
pulling out the AC cord.
ePoint the cursor to [INDUSTRY INIT], set to “ON” using [+]/[-] of the [VOL] key, and press
the [ENT] key.
The version confirmation screen appears on the green screen. It is completed when [SUC-
CESS] is displayed at the top.
(if error occurs, [ERROR] is displayed on the red screen.)
eTurn off the AC power.
The following items are initialized when configuring the factory setting.
1) User set value
2) Channel data (broadcasting frequency, etc.)
3) Password setting value
4) Operating time
5) StandbyCause
6) Auto installation flag
7) V-CHIP block setting value
12. Software version
Main microcomputer
Monitor microcomputer
1.
2.
3. EDID data (Analog RGB)
4. (Reference: File name in the Technical Department)
For analog RGB Input3: 1C509: edid_dsub15_fullhd_v6_256.BIN
13. Writing the inch and model name onto EEPROM
Writing method
Pull out the AC cord.
a
fF
ON
=
Update starts.
Release the power button after 5 seconds.
Copy the application for writing inch/model name (HLI2ZMA01.USB) and model/inch file (652LE920.MDL) to the USB memory.
Hold down the power button and insert the AC cord.
LE920 «—-—— _—_— The inch and model name are displayed
UPGRADE SUCCESS
6. Pull out the AC cord.
Modeil/inch file
+ 52LE920.MDL
+ 60LE920.MDL
* 32 inch is not necessary.
NOTE: When replacing the main PWB, make sure to perform the writing the inch and model name onto EEPROM
5-14

Sharp LC-52LE920UN Specifications

General

Brand	Sharp
Model	LC-52LE920UN
Category	TV
Language	English