E - 6
OPERATION OF CONTROL PANEL
MICROWAVE COOKING
1. Set the microwave POWER CONTROL to the desired setting.
2. Set the TIMER to the desired cooking time.
• The oven startscooking, and the light display will count down.
• When cooking has fi nished, the TIMER will return to “O”, the
audible signal will sound, and the oven and oven lamp will turn off
automatically.
NOTES
1. This model can be programmed up to 30 minutes.
The input unit of cooking or defrosting time varies from 15 seconds to 5 minutes, depending on the total
cooking/defrosting time, as marked on the LIGHT DISPLAY.
2. Your microwave oven is equipped with as safety function to avoid unintended use. The TIMER can be
set to operate the microwave oven only within 3 minutes after a cooking cycle ends or after closing the
oven door. Otherwise the oven door must be opened and closed again, before the TIMER can be set.
3. If you wish to stop cooking before the cooking time has elapsed, turn the TIMER back to “O” (off), or open
the oven door.
The oven door may be opened at any time during cooking.
The
TIMER
will stop to indicate how much cooking time remains. To continue cooking, close the door.
If you wish to change the cooking time during cooking, simply turn the TIMER to the desired new
setting.
WARNING
Be sure to turn the TIMER back to “O” (off) position after cooking, or the oven will start when
the oven door is closed.
•
•
•
R-248 [02 EN+TOC].indd Sec1:6R-248 [02 EN+TOC].indd Sec1:6 5/11/11 9:23:29 AM5/11/11 9:23:29 AM
To Next Page
Loading...
Need help?
General
