Device Management
3.2Configuring the Device
Ethernet Ports
Connect any of the available Ethernet ports on the device to a management
switch and access the RUGGEDCOM RSG909R console and Web interfaces via the
device's IP address. The factory default IP address for the RUGGEDCOM RSG909R is
https://192.168.0.1.
For more information about available ports, refer to "Communication Ports (Page
27)".
3.2 Configuring the Device
Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM RSG909R interface.
For more information about configuring the device, refer to the RUGGEDCOM ROS
Configuration Manual associated with the installed software release.
26
RUGGEDCOM RSG909R
Installation Manual, 02/2021, C79000-G8976-1388-12
To Next Page
Loading...
Need help?
General