Installing software
5
5.1 Setting up the operator panel
To install the software of the operator panel, you require an SD card, e.g.
6AV2181-8XP00-0AX0. Order the SD card via the Industry Mall (https://
mall.industry.siemens.com/goos/WelcomePage.aspx?regionUrl=/&language=en).
The software for the operator panel is on the CompactFlash card supplied with the converter.
If you have to install the software for the operator panel, proceed as follows:
1. Copy the HMI software "HMI_software_GH150_V….zip" from the product documentation
CD of the converter to your PC.
2. Unpack the file on the SD card. The "SIMATIC.HMI" folder is displayed on the SD card.
3. Insert the SD card in the system slot ① of the operator panel.
① System slot
② Data slot
Figure 5-1 Card slots
4. Start the operator panel by switching on the power supply. The software is installed.
5. Confirm that you want the existing HMI project to be overwritten.
6. After completing the software installation, insert the SD card in the data slot ② of the
operator panel.
TP900 Function Manual
Function Manual, 10/2016, A5E39487277A 29
To Next Page
Loading...
Need help?
General
