Preface
CP 443-1 Advanced (GX30)
Manual, 03/2019, C79000-G8976-C256-05
5
● SIMATIC NET Industrial Ethernet Security - Basics and Application, configuration manual,
see /17/ (Page 121)
● Program blocks for SIMATIC NET S7 CPs - programming manual, see /12/ (Page 120)
Contains the detailed description of the program blocks for the following services:
– Open communications services
– Access coordination with FETCH/WRITE
– Connection and system diagnostics
– FTP services
– Programmed connections and IP configuration
– PROFINET
Current version of the manual and Information on the Internet
You will find the current version of this document and further information (e.g. FAQs) on
using the CP on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/15353)
Select the appropriate entry type in the filter settings.
CP documentation in the Manual Collection (article number A5E00069051)
The "SIMATIC NET Manual Collection" DVD contains the manuals of all SIMATIC NET
products current at the time it was created. It is updated at regular intervals.
Version History / Current Downloads for the SIMATIC NET S7 CPs
The "Version History/Current Downloads for SIMATIC NET S7 CPs" document provides
information on all CPs available up to now for SIMATIC S7 (Industrial Ethernet, PROFIBUS,
IE/PB Link).
The current version of these documents can be found on the Internet at the following
address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/9836605)
Address label: Unique MAC address preset for the CP
The CP is supplied with total of 6 default MAC addresses with the following assignment:
● Gigabit interface
● PROFINET interface
● 1 MAC address for each port of the PROFINET interface
The two MAC addresses of the PROFINET interface and the gigabit interface are printed on
the housing.The MAC address of the PROFINET interface is printed on the housing.
To Next Page
Loading...
Need help?
General
