Siemens SIMATIC NET SCALANCE SC-600 User Manual

Installation
5.2 Types of installation
SCALANCE SC-600
Operating Instructions, 10/2021, C79000-G8976-C453-04
45
5.2.1 Mounting on DIN rails
Installation
Note
Note the position of the s
ecuring bar, see also section “Dimension drawings (Page 73)“.
When supplied, the securing bar is in the wall mounting position. To change the position
of the securing bar, refer to the section
“Changing the position of the securing bar
(Page
49)“.
Figure 5-1 DIN rail mounting with securing bar in the wall mounting position.
Securing bar in the wall mounting position (as supplied).
To install the device on a 35 mm DIN rail complying with DIN EN 60715, follow the steps
below:
1. Loosen the knurled screw with your hand or a screwdriver.
2. Place the third housing guide of the device on the top edge of the DIN rail.
3. Press the device down against the DIN rail until the spring securing bar locks in place.
4. When you tighten the knurled screw. you cannot release the securing bar (torque 0.5
Nm). The device is additionally fixed.
5. Connect the electrical connecting cables, refer to the section "Connecting (Page 51)".

Siemens SIMATIC NET SCALANCE SC-600 Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE SC-600
Category	Switch
Language	English