Installation
5.2 Types of installation
SCALANCE SC-600
48 Operating Instructions, 10/2021, C79000-G8976-C453-04
Securing bar in the wall mounting position (as supplied).
To install the device on an S7-1500 standard rail, follow the steps below:
1. Place the first housing guide of the device on the top edge of the standard rail.
2. Swing the device down towards the back against the mounting rail.
3. Loosen the knurled screw with your hand or a screwdriver. The spring mounted
securing bar locks in place.
4. When you tighten the knurled screw. you cannot release the securing bar (torque 0.5
Nm). The device is additionally fixed.
5. Connect the electrical connecting cables, refer to the section "Connecting (Page 51)".
Removal
To remove the device from a standard rail, follow the steps below:
1. Disconnect all connected cables.
2. If necessary, loosen the knurled screw with your hand or a screwdriver.
3. Lever the securing bar down using a screwdriver as far as it will go.
4. Remove the device from the mounting rail with the bar pulled.
5.2.4 Wall mounting
Preparation
Note the position of the securing bar, see also section “Dimension drawings (Page 73)“.
When supplied, the securing bar is in the wall mounting position. You do not need to
prepare the device any further.
If the securing bar is in the rail mounting position, note the section “Changing the
position of the securing bar (Page 49)“.
Tools
To mount the device on a wall, you require the following:
• 2 wall plugs
• 2 fillister head screws
Note
Depending on the mounting surface, use suitable fittings.
To Next Page
Loading...
Need help?
General