Siemens SIMATIC Operating Manual

PDT IFP Monitor Standard
6 Operating Manual, 10/2017, A5E41104536-AB
Panel Drivers and Tools software
1
1.1
Product description
The SIMATIC IPC PDT software installs the "IPC Configuration Center" and, optionally, the
"IFP Ethernet Monitor" software. The existing hardware components are automatically
detected by the associated software.
The most important features of the software are:
● Easy dialog-guided installation
● Simple configuration via the IPC Configuration Center:
– Brightness
– Information
– Screen saver
– Tools
1.2
System requirements
Supported operating systems
The PDT software can run on PCs with the following operating systems:
● Microsoft Windows 32-bit operating system *
– Windows 7 Ultimate SP1
– Windows Embedded Standard 7P/E SP1
● Microsoft Windows 64-bit operating system *
– Windows 7 Ultimate SP1
– Windows Embedded Standard 7P/E SP1
– Microsoft Windows 10 Enterprise, Version 1607 (Build 14393) 64-bit
Microsoft Windows 10 Enterprise, Version 2016 LTSB (Build 14393) 64-bit
Microsoft Windows 10 Enterprise, Version 2015 LTSB (Build 10240) 64-bit
* 2 GB free hard disk memory required.
NOTICE
Windows Embedded Standard 7E on CFast card
For systems with Windows Embedded Standard 7E on a CFast card, the data is
compressed and must be unzipped for the installation. The installation of the PDT software
can take up to 40 minutes.

Siemens SIMATIC Specifications

General

Brand	Siemens
Model	SIMATIC
Category	Control Unit
Language	English