Siemens SINUMERIK 808D Operating Guide

808D Page 69 Operating and Programming — Milling
Additional
Information
Part 1
s
Content
SEQUENCE
Unit Description
This unit describes how to perform simple tasks on the machine and
provides some additional information which may be required to operate
the machine correctly.
Unit Content
RS232
+
USB
Help
Manual
face
milling
R
parameters
Time
change
Save data
Gear
change
RS232
+
USB
RS232 is used to transfer the programs to
and from the NC.
Step 1
Adjust the parameter settings on the PPU to match the settings of the
communication SW on the PC.
Press “Program Manager” on the PPU.
Press the “RS232” SK on the PPU.
Press the “Settings” SK on the PPU.
Adjust the parameters in “Communication settings” to match the settings of
communication SW on PC.
Press the “Save” SK on the PPU.
Press the “Back” SK on the PPU.
It is recommended to use the “SINUCOM PCIN” communication
SW provided by Siemens to transfer the standard program.
End

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English