Information for the Operator
SIP ART PS2 Manual
A5E00074631-01
8
!
W ARNING
The instrument must only be installed and commissioned by qualified
personnel.
The instrument is designed for connection to functional and safety
extra low voltage.
Electrical safety depends only on the power supply equipment.
Pneumatic actuators exert considerable positioning forces. The safety
precautions of the actuator used must therefore be scrupulously
observed during installation and commissioning in order to prevent
injuries.
We explicitly draw your attention to the necessity of observing safety
regulations regarding operation in zones subject to explosion hazard, if
applicable.
0.4 Use as intended
Use as intended for the purpose of this manual means that this product
must only be used for the applications described in the technical
description (see also Chapter 3 of this manual).
The product described in this manual has been developed, manufac-
tured, tested and documented observing the relevant safety standards.
If the handling rules and safety information for configuration, installa-
tion, use as intended and maintenance are observed, there is normally
no danger with regard to material damage or for the health of
personnel. Extra low voltages that are connected must be fed in by
safe isolation.
0.5 Technical Documentation
In addition to this manual, the following documentation is also supplied
with the instrument:
- Leaflet “Operation -- Concise Overview”
explains in visualized form the principle of operation and
parameterization and automatic commissioning.
- “Operating Instructions”
contains the information required for assembly, connection and
commissioning.
To Next Page
Loading...
Need help?
General
