5
6
¯
a Energy
a
§Ç¯ is lit,
a
a
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
a
a
c
a
ÿ
or
a
~
ʋ
ʋ
ʋ
Individual settings
ʑ
Option button Finish in
When a programme is selected, its duration is displayed. You can delay the end of the programme before it begins. The
ready in-time can be set in increments of one hour up to a maximum of 24 hours. Press the Finish in button until the
required number of hours is displayed (h = hour). Choose Start/Reload. Once the programme has begun, no further
adjustment is possible.
ʑ
Spin speed in rpm/ (without final spin)
You can change the displayed spin speed or choose (without final spin, laundry soaks in the last rinsing water,
display panel - - - ). The maximum selectable spin speed depends on the model and which programme is currently
selected.
ʑ
Additional functions aOverview of programmes, page 7
speedPerfect iFor washing in a shorter time with a washing outcome comparable to that of the
standard programme. Maximum load aOverview of programmes, page 7.
ecoPerfect ¢
Energy-optimised washing by reducing the temperature while achieving a consistent
washing result. The washing temperature is lower than the selected temperature. For
special hygiene requirements, it is recommended that a higher temperature be
selected or the speedPerfect i option.
Less Ironing Special spin sequence with subsequent fluffing. Gentle final spin: residual moisture in
the laundry slightly increased.
Extra Rinse Additional rinse cycle. For areas with very soft water or for further enhancing the spin
result.
ʑ
Childproof lock
ª¥in the display panel You can lock the washing machine to prevent the functions you have set from being
changed inadvertently.
To activate: press and hold the Start/Reload button for approx. 5 seconds after the
programme has started. ª¥ appears in the display panel for approx. 5 seconds, then
the Finish-in time is shown again.
To deactivate: press and hold the Start/Reload button for approx. 5 seconds.
Note: If a button is pressed when the childproof lock is active, ª¥ lights up for
approx. 5 seconds, then the Finish-in time is displayed again.
ª¥lights up continouously if the programme selector is adjusted when the Childlock
is active.
ʑ
Reloading
§
in the display panel
Press Start/Reload if you want to add additional items of laundry after the programme
has started. The machine checks whether reloading is possible.
§ lits: reloading is possible.
ǯ flashes: wait until § lights.
Note: do not open the door until § is lit.
ǯ: it is not possible to reload.
Note: for safety reasons, the washing machine door remains locked when the water
level and/or temperature is high, or during spinning.
To continue the programme, press the Start/Reload
button.
ʑ
Energy saving mode
The display panel lighting goes out after a few minutes, Start/Reload flashes. Press any button to switch on the lighting.
ʑ
Start/Reload
To start the programme or to subsequently load additional laundry, and to activate/deactivate the childproof lock.
Individual settings
ʑ
Signal
Important information
Protecting the laundry and the machine
– When determining the dosage of all washing powders, additives and cleaning agents, you must follow the
manufacturer's instructions..
– Empty all pockets
– Check for metal items (paper-clips, etc.).
– Wash delicates in a laundry bag (tights, curtains, underwired bras).
– Fasten zips, do up any buttons.
– Brush sand out of pockets and collars.
– Remove curtain fittings or place in the laundry bag.
Laundry with varying degrees of soiling
Wash new items of clothing separately.
light Do not prewash. If required, choose the additional function speedPerfecti.
Pre-treat any stains as necessary.
intense wash Load less laundry. Choose a programme with a prewash.
Soaking Load laundry of the same colour.
Pour soaking agent/detergent into compartment II in accordance with the manufacturer's instructions. Turn the
programme selector to Cotton30 °C and press Start/Reload. After approx. 10 minutes, press Start/Reload to pause
the programme. Once the required soaking time has elapsed, press Start/Reloadagain to continue the programme, or
select a different programme.
Starch Laundry should not be treated with fabric softener.
Starching is possible in all wash programmes if liquid starch is used. Pour the starch in accordance with the
manufacturer's instructions into fabric softener compartment ~ (rinse first if necessary).
Dyeing / Bleaching
Dye should only be used in normal household quantities. Salt may damage stainless steel. Always follow the dye
manufacturer's instructions. Do not use the washing machine for bleaching clothes.
Textile Guard Laundry must not be treated with fabric softener.
Clean the detergent drawer thoroughly to remove fabric softener residue.
Special detergent and waterproofing agent suitable for machine washing are available from sports shops. Dosage according to
the manufacturer's instructions:
1. Place the special detergent for outdoor clothing in compartment II and
2. pour impregnating agent (max. 170 ml) into the ~compartment.
Set the programme selector to Textile Guard. Set the temperature.
Press Start/Reload. Final treatment of the laundry in accordance with the manufacturer's instructions.
Insert for liquid detergent depending on model
Position the insert for dispensing liquid detergent:
– Remove the detergent drawer completely a page 9
– Slide the insert forwards and click into place.
Do not use the insert (slide upwards): for gel detergents and washing powder,
for programmes with + Prewash and End time option.
Set to o
1 step, the display
panel lights up
press and
hold
+
1 step, release
set to o
setting the volume*setting the volume* 1 step
* if necessary,
select the function
several times
1.
Activating the mode for
setting the signal
volume
2. Setting the volume for...
Button signals Information signals
direct
~
ª¥
a
a
5
6
a
1ü2c¯
ª¥
a
5
6
To Next Page
Loading...
Need help?
General