22
Ø End of programme by Rinse Hold
1. Select Spin (If required, adjust the spin speed) or Drain.
2. Select Start/Reload
Ü.
End of the programme
Finished, remove washing is indicated on the display panel.
If Foam has been detected is also indicated on the display panel,
the washing machine has detected too much foam during the
wash programme and therefore automatically activates additional
rinse cycles to eliminate the foam.
²
Dose less detergent in the next wash cycle with the same load.
Rinse hold reached:
Select "spin" or "drain"
and then "start".
Spin Drain
bb
v
Finished, remove washing
is also indicated on the display panel,
www.devicemanuals.eu
is also indicated on the display panel,
the washing machine has detected too much foam during the
www.devicemanuals.eu
the washing machine has detected too much foam during the
wash programme and therefore automatically activates additional
www.devicemanuals.eu
wash programme and therefore automatically activates additional
rinse cycles to eliminate the foam.
www.devicemanuals.eu
rinse cycles to eliminate the foam.
Dose less detergent in the next wash cycle with the same load.
www.devicemanuals.eu
Dose less detergent in the next wash cycle with the same load.
Finished, remove washing
www.devicemanuals.eu
Finished, remove washing
To Next Page
Loading...
Need help?
General