Silvercrest 303937 User Manual

29 GB/MT
Safety / Setting up
Wear suitable protective gloves at
all times if such an event occurs.
In the event of a leakage of batter-
ies / rechargeable batteries, imme-
diately remove them from the
product to prevent damage.
Only use the same type of batteries /
rechargeable batteries. Do not mix
used and new batteries / recharge-
able batteries.
Remove batteries / rechargeable
batteries if the product will not be
used for a longer period.
Risk of damage of the product
Only use the specified type of bat-
tery / rechargeable battery!
Insert batteries / rechargeable bat-
teries according to polarity marks
(+) and (-) on the battery / recharge-
able battery and the product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Q
Setting up
Preparing the remote
control
Note: The button cell is already in the
battery compartment. Remove the con-
tract strips by opening the battery com-
partment as described below.
Replacing the battery
CAUTION! Danger of explosion
in the case of improper battery re-
placement. Only replace with the
same or equivalent battery type.
1. Open the battery compartment on
the back of the remote control by
turning the battery compartment
cover
4
anti-clockwise with the
aid of a coin or a screwdriver, then
removing the lid (open).
2.
Replace the button cell type CR
2032.
Make sure you fit the battery
with the correct polarity (+ = up).
3. Place the battery compartment
cover
4
back on and lock it in
place by turning it in a clockwise
direction (close).
4. Press one of the ON / OFF buttons
2
or
3
to test whether the remote
control works; if it does, the power
indicator light will come on
1
.
Q
Setting up the remote-
controlled socket
1. Plug the remote-controlled socket
into an earthed household socket.
2. The LED operating status display
5
will now flash slowly for approx.
30 seconds after plugging in.
3. Aim the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
4. With the LED operating status dis-
play
5
flashing, press the desired
ON button of the channel ON /OFF

Silvercrest 303937 Specifications

General

Brand	Silvercrest
Model	303937
Category	Accessories
Language	English