GB
│
IE
│
NI
│
11 ■
SKHK 40 A1
♦ To terminate the Bluetooth
®
connection, either disable the
Bluetooth
®
function on the Bluetooth
®
playback device or
hold down the Bluetooth
®
pairing button 4 for about
2 seconds until the operating/charging LED 0 flashes orange
and blue alternately. The headphones are now in pairing mode
again.
♦ Alternatively, switch the headphones off as described above
to deactivate the Bluetooth
®
function.
NOTE
► The next time you turn on the headphones, they will automat-
ically connect to the last Bluetooth
®
playback device that
was connected. If your Bluetooth
®
playback device does not
automatically reconnect to the headphones, you will have to
re-establish the connection manually. A detailed description of
how to do this can be found in the operating manual for your
Bluetooth
®
playback device.
► If no Bluetooth
®
connection can be made within 2 minutes,
pairing mode ends and the headphones switch off automatically.
► Ensure that the headphones are no more than 10 metres away
from the Bluetooth
®
playback device. Make sure that there
are no barriers or electronic devices placed between them.
►
As soon as you connect the AUX IN socket 8 to the audio
cable
e, the Bluetooth
®
function is deactivated and the
headphones change to AUX IN mode. The Bluetooth
®
function
can only be reactivated once you remove the audio cable e
from the AUX IN socket 8.
Music playback via Bluetooth
®
The following music playback functions are only available when the
headphones and the playback device are connected to each other
via Bluetooth
®
.
NOTE
► It may be the case that not all functions will be supported de-
pending on the playback device used and its operating system.
To Next Page
Need help?
General
