■ 18
│
GB
│
IE
│
NI SEMM 1470 A1
NOTE
► You can stop the preparation at any time by pressing any button.
NOTE
► If you want to add a little extra frothed milk to your drink: press the "Large"
cappuccino button
2x in a row. The control lamp for the "Small"
cappuccino button !
and the control lamp for the "Large" cappuccino
button light up and frothed milk comes out of the milk nozzle .
Stop the milk output by pressing any button. The milk will stop coming out
automatically after 70 seconds.
12) Switch the appliance off using the on/off switch %.
13) Clean the appliance as described in the section “Cleaning and Care”. For
hygienic reasons, the milk tank , the milk tank lid and the milk
nozzle must be cleaned thoroughly after every time you make milk froth.
Failure to do so will affect the quality of the milk froth and may lead to the
formation of germs!
NOTE
► If you do not turn off the appliance with the on/off switch %, the appliance
will switch itself into power saving mode automatically after approx.
15minutes if no other button is pushed. If you want to make another drink,
simply press any button. The appliance heats back up.
Changing the duration of the milk froth output
NOTE
►
You can adjust the amount of the milk froth by turning the "Milk quantity"
knob and also the duration of the milk output. The further you turn the
"Milk quantity" knob toward "
" the more milk/milk froth will come out
of the milk nozzle over the same amount of time. Make sure you do not
turn the "Milk quantity" knob further than the " " marking. Otherwise
you will be in cleaning mode (see section "Cleaning and care").
You can customise the duration of the milk froth output for the “Small
cappuccino” and “Large cappuccino” programmes:
To Next Page
Loading...
Need help?
General
