■ 28
│
GB
│
IE
│
NI SEMM 1470 A1
Cleaning the espresso sieves, sieve holder and
espressooutlet
Remove all used powder from the espresso sieves / after every drink
preparation.
Clean the espresso sieves / , the sieve holder , and the espresso outlet -
regularly.
1) After you have prepared espresso/cappuccino/latte macchiato and removed
the sieve holder ,:
– Fix the espresso sieve / in place by flipping the sieve blocker
upwards and holding it in place.
– Knock the espresso powder out of the espresso sieve / .
– Flip the sieve blocker back down again.
– Remove the espresso sieve / from the sieve holder ,.
– Clean the espresso sieve / and the sieve holder , in warm water
with a little mild washing-up liquid. Rinse all the parts off afterwards
using clean water.
NOTE
The espresso sieves / are also suitable for cleaning in the
dishwasher.
2) Replace the sieve holder , in the appliance without the espresso
sieve / .
3) Fill the water tank 6 with water (approx. 200ml).
4) Place a suitably large, empty container onto the drip grille .
5) Switch the appliance on using the on/off switch % and wait until all control
lamps light up permanently.
6) Press the “Small” espresso button .
. The water comes out of the
espresso outlet - and rinses out the pipes. As soon as the water stops
coming out of the espresso outlet -, the cleaning process is complete.
NOTE
► If you want to descale the water tank 6 and the pipes, proceed as
described in the section "Descaling mode".
NOTE
► You can store the sieve holder , and the espresso sieves / in the
holders 1 next to the water tank 6.
To Next Page
Loading...
Need help?
General
