21 GB/IE/NI/CY
Do not use solvents, petrol, etc.
These would damage the
product.
Empty the dust collector
21
before cleaning
(see chapter “Emptying the dust collector”)
and thoroughly tap it out.
Cleaning the surface of the product:
When cleaning the surfaces, e.g. of the main
unit
4
, rechargeable battery
2
or electric
floor brush
14
, use a feather duster or soft,
slightly moistened cloth for persistent dirt.
Cleaning the accessories:
Regularly remove any hair and dirt from the
accessory parts.
Clean the crevice nozzle
13
, the dust brush
12
and the brush
11
under running water. Allow
all accessory parts to dry thoroughly before
using or storing them again.
Cleaning the rotating brush roller:
Remove the electric floor brush
14
from the
aluminium suction tube
16
. To do so, press the
release button
15
on the aluminium suction
tube
16
and remove the electric floor brush
14
.
Turn the electric floor brush
14
around.
Use a flat-tip screwdriver to turn the fixing screw
14 c
of the locking mechanism
14 b
anticlock-
wise towards the
- symbol.
14c
14b
14
14 a
Carefully fold up the locking mechanism
14 b
and then remove the rotating brush roller
14 a
from the housing of the electric floor brush
14
.
14 a
14b
Clean the rotating brush roller
14 a
by removing
any hair or dirt.
Also remove any dirt from the housing of the
electric floor brush
14
.
Then replace the rotating brush roller
14 a
in
the housing of the electric floor brush
14
.
Then carefully press the locking mechanism
14 b
down again.
Attach the rotating brush roller
14 a
by turning
the fixing screw
14 c
using a flat-tip screwdriver
clockwise in the direction of the
- symbol.
Check that it is positioned correctly.
Storage
Disconnect the power supply if
the product will not be used for
an extended period.
Remove the rechargeable battery
2
from the holder in the handle
1
of the main unit
4
(see chap-
ter “Charging the rechargeable
battery”) and store it outside of
the main unit
4
.
To Next Page
Loading...
Need help?
General
