Silvercrest SFB 10.1 A1 User Manual

- 24 -
Foroperation
> To operate one of the programmed devices with the URC
rst press the corresponding device button e. Then point
the URC to this device and press the desired button.
> Put the number buttons o exactly as you do with the
original remote control. Before you make a two digit
entry press, if necessary, the
button a.
> Press the FAV/EPG button 1( to start the electronic pro-
gramme guide of a device equipped with this function.
> If you press the S button r the date is superimposed for
10 seconds in the LCD display q below and on the right.
> Whilst you hold down one of the device buttons e the
active code for this device will be superimposed below to
the right in the LCD display q.
> Via the MENU button k you access the dialogue for the
setting of the respective target device.
> Press the illumination button dto switch the display and
button illuminations on and/or off.
All OFF
 Tips:
With the button ALL OFF (all o) w all devices that
are switched on can be automatically switched o. This func-
tion can switch on again devices that have already been
switched o (depending on the device). For this, press and
hold the ALL OFF button w for a few seconds. It may take up
to 10 seconds before all devices are switched o. This will
only function under the following circumstances:
1. A visible connection exists between all the devices and
the URC.
2. Automatic code search, brand code search and MACRO
function are not active.
3. All target devices must be suitable for remote control
switch o.
To again switch on all devices automatically hold down once
more the button
w until all devices are switched on.
Cleaningandstorage
 Attention!
Ensure that moisture cannot permeate into the device
during cleaning! Otherwise there is the danger of
causing irreparable damage to the device!
> Clean the housing of the device exclusively with a soft
moist cloth and a mild dishwashing detergent.
> Store the device exclusively in an environment that com-
plies with the specications given in the technical data.
> Before storing remove the batteries so that they will not
cause damage to the device if, during storage, they
happen to leak.
BDA_SFB 10.1 A1 - DT-62327_gb.indd 24 19.04.2011 15:01:58

Silvercrest SFB 10.1 A1 Specifications

General

Brand	Silvercrest
Model	SFB 10.1 A1
Category	Remote Control
Language	English