Silvercrest SFB 10.1 C3 User Manual

SilverCrest SFB 10.1 C3
20 - English
Resetting to factory defaults (RESET)
1. Press and hold the button for 3 seconds.
2. Press , select “CONFIGURE” and press to confirm.
3. Press , select “RESET” and press to confirm.
4. Press and choose between “ALL RESET” and
“MODE”.
5. Press to confirm your entry.
Choosing “ALL RESET” will restore the settings for all devices. The
procedure is as follows:
6. After choosing “ALL RESET”, press to confirm. The display will
read „CONFIRM RST“.
You can still press to cancel the reset at this point.
7. Press to confirm your entry. The display reads “OK” and then
returns to the start window.
The day of the week and the time are not reset.
Choosing “MODE” restores the settings for the selected device only. The
procedure is as follows:
8. After you confirm your selection “MODE” by pressing , the
display shows the device currently selected. Select the device you
want by pressing the corresponding device button.
9. After confirming your choice with , the display will read
"CONFIRM RST".
You can still press to cancel the reset at this point.
10. Press to confirm your entry. The display reads “OK” and then
returns to the start window.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
The learn function (LEARNING)
Programming via the learn function (LEARN KEY)
This function allows the remote control to learn individual buttons for a
selected device.
1. Press the device button for the device that you wish to program.
2. Press and hold the button for 3 seconds.
3. Press , select “LEARNING” and press to confirm.
4. Press , select “LEARN KEY” and press to confirm.
5. The display reads “SELECT KEY”.
All buttons except the device buttons support learning.
6. Press the button that you wish to learn a command. The display
reads “WAITING”.
7. Place the original remote control so its IR LED and the IR LED (2) of
your 10-in-1 remot e control face each other and are no greater than
5 cm apart.
8. Next press the button on the original remote control from which you
wish to copy the signal. The successful detection of the button code is
indicated by “SUCCESS” on the display.

Silvercrest SFB 10.1 C3 Specifications

General

Brand	Silvercrest
Model	SFB 10.1 C3
Category	Remote Control
Language	English