Silvercrest SKR D1 C3 User Manual

20 GB
NOTES:
 When the alarm sounds, press [3] to turn
the alarm off.
 When Alarm 1 sounds, flashes on the
display [4].
 The volume gradually increases.
 After the alarm duration has elapsed,
the product will return to standby mode
automatically.
 <FM> or <DAB> alarm: When the alarm
sounds, the radio station appears on the
display [4].
 Snooze function
 In ON mode, press and hold SELECT/
ENTER/SNOOZE [1] while the alarm is
ringing. The alarm reactivates after approx.
9 minutes.
 Timer function
The product has a practical kitchen timer with
which you can monitor cooking and baking times,
for example. You can set 2 kitchen timers.
 Setting and operating the
kitchen timer
 Press TIMER/SLEEP [9] to toggle between
Timer 1 and Timer 2.
 Turn VOLUME/START/RESET [7] to select
the countdown time.
 Push VOLUME/START/RESET [7] to
confirm. T1 or T2 appears on the display [4].
The countdown starts immediately.
 Press TIMER/SLEEP [9] to check the
countdown time.
 A warning signal sounds at 30, 15, 10 and
5 seconds before the countdown elapses.
 At the end of the countdown, an alarm signal
sounds at maximum volume. Press any key to
turn the alarm off. T1 or T2 disappears from
the display [4].
NOTES:
 Timer 1 can be set from 1 minute up to 3 hours
59 minutes in increments of 1 minute. If you set
the countdown between 1 and 4 minutes, the
time will be shown in “mm:ss” format. If you set
the countdown to 5 minutes or more, the time
will be shown in “hh:mm” format.
 Timer 2 can be set from 5 minutes up to
3 hours 55 minutes in increments of 5 minutes.
The time will be shown in “mm:ss” format.
 If you do not make any changes to the settings
for about 15 seconds, the product will switch
back to the previous operating mode without
saving the settings.
 Cancelling the kitchen timer
 Briefly press TIMER/SLEEP [9] to select the
timer you wish to cancel (T1 or T2).
 Push and hold VOLUME/START/RESET [7]
for 2 seconds until Off appears in the
display [4].
 Power reserve
 The power reserve is used to store data /
settings if the product has been accidentally
disconnected from the power supply.
 In the event of a power failure, the display will
extinguish, the clock will continue working, but
there will be no alarm.

Silvercrest SKR D1 C3 Specifications

General

Brand	Silvercrest
Model	SKR D1 C3
Category	Radio
Language	English