Simplicity 16GTH User Manual

Operation
MOWING SUGGESTIONS
When mowing for the first time, operate on a level surface at
a slow ground speed until you become familiar with the
controls and handling of the machine. Make sure mower is
properly installed and adjustments are correct.
Set the throttle between 3/4 to full and use hydrostatic
control lever to control ground speed.
The size and type of area to be mowed determine the best
mowing pattern to use.
Obstructions such as trees, fences and buildings must be
considered. Where possible, make one or two passes in a
clockwise direction around the outside of the area to keep
cut grass off fences and walks. The remainder of the mowing
should be done in a counterclockwise direction so the
clippings are dispersed on the cut area.
On moderate size, frequently-mowed lawns where grass is
light and dry, it is sometimes practical to mow in a clockwise
direction so that clippings are thrown toward the center of
the lawn and concentrated for pickup and removal.
Where possible, keep the left side of the mower toward trees,
posts, or other obstacles on the first pass around the
obstacles to keep hand trimming to a minimum.
Most lawns should be mowed to keep the grass
approximately two to three inches (50 to 76 mm) high. Best
results are obtained by cutting often and not too short. To
help keep a green lawn, never mow more than one third off
the height of the grass, or a maximum of one inch (25 mm),
in one mowing.
On thick, or springy grass or soft ground, the mower rollers
may sink into the ground giving too low a cut. Adjust the
cutting height as necessary.
For best appearance, grass should be cut in the after or early
evening (in daylight) when it is free of external moisture.
Where possible, change mowing patterns occasionally to
eliminate matting, graining or a corrugated appearance.
16

Simplicity 16GTH Specifications

General

Brand	Simplicity
Model	16GTH
Category	Lawn Mower
Language	English