12
Features & Controls
Figure 2. Engaging the Parking Brake
A. Ground Speed Pedals
B. Brake Pedal
C. Parking Brake Knob
Parking Brake Function
Applying the Parking Brake - See Figure 2. To lock
the parking brake, release the ground speed pedals (A),
fully depress the brake pedal (B), pull UP on the parking
brake knob (C), and then release brake pedal.
Releasing the Parking Brake - See Figure 2. To
release the parking brake, fully depress the brake pedal
(B) and push the parking brake knob (C) DOWN.
IMPORTANT NOTE: The tractor’s hydraulic attachment
lift will not work when the parking brake is engaged.
Automatic Controlled Traction
(w/o 4WD)
What is Automatic Controlled Traction?
Automatic Controlled Traction (ACT) is an exclusive fea-
ture of our transmissions that provides improved traction.
ACT applies a preset amount of torque to both rear
wheels even if one starts slipping (a transmission without
ACT will lose traction completely if one rear wheel starts
slipping). This preset torque is just enough to provide
additional traction, and still allow the wheels to turn at dif-
ferent speeds in a tight turn without damaging the lawn.
A
B
C
What to Expect from Your ACT Tractor
For the most part, while using your tractor you will not
notice ACT working, and you will simply become accus-
tomed to increased traction an ACT transmission pro-
vides.
Under certain circumstances the ACT system limit can
be exceeded, and one of the rear wheels may slip (for
instance if trying to turn up a hill while accelerating).
This is normal. If you start to lose traction, do not speed
up. Instead, slow to a stop, straighten the steering
wheel, and slowly accelerate. Stopping the tractor
allows the transmission to regain more traction.
Attachment Lift Control Lever
When using the mower deck, lift the deck off the ground
while transporting to and from the job site. DO NOT cut
with the mower in the raised, transport position.
Hydraulic Lift Models: The attachment lift control lever
raises and lowers attachments that utilize the tractor’s
hydraulic lift cylinder. Pushing the lever forward lowers
the attachment while pulling the lever back raises the
attachment.
IMPORTANT NOTE - On models equipped with
hydraulic lift, the attachment lift will not work when the
parking brake is engaged.
Manual Lift Models: The attachment lift control lever
raises and lowers attachments that utilize the tractor’s
manual lift linkage. To lower an attachment: pull the
lever back slightly, depress the release button, and push
the lever forward until it locks in the lowered position. To
raise an attachment: push the lever forward slightly,
depress the release button, then pull the lever back until
it locks in the raised position.
To Next Page
Loading...
Need help?
General
