Simplicity Conquest Series User Manual

44
Troubleshooting, Adjustment, & Service
Arbor Drive Belt Replacement
NOTE: Be sure to use only genuine Simplicity replace-
ment parts.
1. Park the tractor on a smooth, level surface such as a
concrete floor. Disengage the PTO, turn off the
engine and lock the parking brake. Remove the key.
2. Remove the mower from the tractor. See Mower
Removal in the Operation section.
3. Remove the capscrews securing the right-hand arbor
cover (B, Figure 55). Remove three capscrews secur-
ing left-hand arbor cover (D).
4. Using a pair of locking pliers or a spring puller,
remove the idler pulley spring (C, Figure 55) from slot
in deck.
5. Loosen capscrew (A, Figure 55) securing the idler
pulley to the bracket. The belt can now be slipped
between the pulley and idler bracket hub.
6. Install a new belt as shown in Figure 56. Make sure
that V-side of belt runs in arbor pulley (A) grooves
and flat side of belt runs against idler pulley (B).
7. Tighten the capscrew (A, Figure 55).
8. Reinstall spring (C, Figures 55) into its slot in mower
deck.
9. Reinstall the left and right arbor covers (B and D,
Figures 55).
10. Install the mower onto the tractor.
FRONT
Figure 56. Mower Deck Drive Belt Routing
A. Arbor Drive Pulley (V-sided)
B. Idler Pulley (Flat-sided)
A
A
A
B
D
B
C
A
Figure 55. Mower Deck
A. Capscrew
B. Right-hand Arbor Cover
C. Spring
D. Left-hand Arbor Cover
Not for
Reproduction

Simplicity Conquest Series Specifications

General

Brand	Simplicity
Model	Conquest Series
Category	Lawn Mower
Language	English