* The automatic needle threader is a factory installed option. If
your machine has this option use the following instructions:
- Raise the needle to its highest position.
- Press lever (A) down as far as it will go.
- The threader automatically swings to the threading position
(B).
- Pass thread around thread guide (C).
- Pass the thread in front of the needle around the hook (D)
from bottom to top.
- Release lever (A).
- Pull the thread through the needle eye.
Attention:
Turn power switch to off ("O")!
14
Automatic needle threader (optional)
A
B
D
C
A
C
B
D
A
1
2
To Next Page
Loading...
Need help?
General
