20
12. HOW TO CHANGE THREADS /
TIE ON METHOD
• To change thread type or color, clip thread near the
spool.
• Place new thread on stand.
• Tie new thread and old thread ends together.
• Clip thread tails to 2 ~ 3cm (1 inch) length.
If clipped too short, threads may come untied.
• Pull the threads through the machine one at a time.
• If threads do not pull easily, check for tangles on
thread guides or looping under thread stand.
• When pulling thread through the needle, STOP when
the knot is in front of the needle.
• Cut the thread, and insert it through the needle.
• Return tension dials to previous settings.
• Firmly pull both thread to test knot security.
• Note tension dial settings.
• Turn the tension dials down until the dial stops.
3.5
To Next Page
Loading...
Need help?
General
Weight and Dimensions
