1. Make sure that the needle is in the highest position and the
presser foot is lifted. The presser foot release lever extends
out the back of the presser foot holder. Press this lever to
release the presser foot.
2. To attach a presser foot to the holder, place the desired
presser foot with its pin directly under the slot in the
presser foot holder. Lower the presser foot lifter and the
presser foot will snap into place.
Note: If you find it difficult to place the presser foot in the
correct position, keep the release lever pressed while
lowering the presser foot. Use your thumb to carefully
guide the presser foot into the correct position and it will
snap into place.
Preparations – 17
English
To Next Page
Loading...
Need help?
General
