›
To Separate, end the connection by pressing the button
→ →
Blue-
tooth
→
Bluetooth audio (A2DP / AVRCP)
.
Supported audio sources and file formats
Supported audio sources
Source Interface Type Specification
File sys-
tem
SD card SD reader Standard size SD, SDHC, SDXC
FAT16
FAT32
exFAT
USB-
devices
USB 1.x; 2.x
and 3.x or
higher with
support of
USB 2.x
MSC
USB stick;
HDD (without any
special software);
The MSC mode sup-
ports USB devices
MTP
Devices with the
Android operating
system or Windows
mobile (mobile
phone, tablet)
Apple
Devices with the iOS
operating system
(iPhone, iPod, iPad)
CD
(Applies to
blues)
CD
-Drive
Audio CD (Up to 80
min);
CD-R / RW (Up to
700 MB);
ISO9660;
Joliet (Level 1,2,3);
UDF 1.x;
UDF 2.x
-
Supported audio file formats
Codec type
(File formats)
File suffix Max. bit rate
Maximum
sampling
rate
Playlists
Windows Media
Audio
9 and 10
wma 384 kbit / s
48 kHz
m3u
pls
wpl
m3u8
asx
MPEG-1 and 2
Layer 3
mp3 320 kbit / s
The audio sources divided into areas using GPT standards (GUID partition ta-
ble) are not supported by the device.
Files that are protected by Digital Rights Management (DRM) technology can-
not be played back by the device.
Phone
Introduction
Applies to Swing.
This chapter contains information on the following subjects:
Conditions for pairing 89
Pairing and connection process 89
Telephone 90
Enter and select phone number 90
List of telephone contacts 91
Preferred contacts (favourites) 91
Call list 92
Phone call 92
Managing paired Bluetooth devices 93
This chapter covers the operation of a Bluetooth
®
device connected to the tel-
ephone.
To pair a telephone with the device using Bluetooth
®
, it is necessary to pair
the two devices.
The range of the connection to the hands-free system is limited to the passen-
ger compartment.
With the device, a phone can be connected. The telephone can also be a Blue-
tooth
®
player at the same time.
Up to 20 external devices can be paired with the device. After reaching the
maximum number, the pairing of the next external device will replace that of
the device that has not been used for the longest period of time.
A connection with a telephone that is already paired does not require pairing.
It is enough to find the telephone that has been paired in the list of paired
phones and make the connection.
For phones with multiple SIM cards,calls can be answered using any SIM card
from the connected phone depending on the model of the connected phone.
For outgoing calls, it depends on the type of connected telephone, either only
the primary SIM card or one of the other SIM cards can be selected.
88
Infotainment
To Next Page
Loading...
Need help?
General
