Skywalk RANGE X-ALPS2 User Manual

Features 4140 Features
EN
To fill the protector:
1. Lay the harness lengthwise sideways on the ground.
2. Make sure that no heavy objects or weights are lying on the protector. That would make
filling more difficult.
3. Connect the tube from the rear storage compartment with the inflation bag and keep
inflating the protector until it can´t take any more air (pic 1+2).
4. Make sure that the protector is correctly positioned in its compartment and has not
slipped during inflation. It might be necessary to reposition it to make sure it is properly
seated in its intended compartment.
5. Separate the inflation bag from the protector. Kink the hose first, do not pull on the
inflation bag and grab directly to the valve, otherwise the valve can tear out (pic 3).
6. Press the bent hose into the designated sleeve, making sure that no further air escapes
from the protector during the process, the bent end sits firmly in the sleeve
and the yellow plug seals the hose (pic 4+5).
CAUTION
THE PROTECTOR MUST BE SEALED AFTER INFLATION WITHIN 3 SECONDS
TO ENSURE THE FUNCTIONALITY ACCORDING TO LTF 91/09. IF THIS IS NOT
DONE, PROTECTION WILL BE INSUFFICIENT!
After landing, just pull the end of the tube out of the sleeve and remove the yellow plug
to let the air out of the protector. Leave the tube open when packing the harness in the
rucksack. This will squeeze the remaining air out by compressing it. Always make sure that
no sharp objects, such as poles, come into contact with the harness.
CAUTION
THE PROTECTOR MUST BE INFLATED ONLY WITH THE INFLATION BAG
OR MOUTH!! PUMPS OR ANY KIND OF EXTERNAL INFLATION IS EXPRESS-
LY FORBIDDEN!
3
5
4
2
1

Skywalk RANGE X-ALPS2 Specifications

General

Brand	Skywalk
Model	RANGE X-ALPS2
Category	Accessories
Language	English