SMC Networks ISE35 User Manual

-17-
No.PS※※-OMJ0004-E
5. Hysteresis ( )
The hysteresis can be set.
<How to perform>
1. Keep pressing the button for 2 seconds or longer in the measurement mode.
After [ ] is indicated, press the button four times.
Then, [ ] and current setting appears in turn.
2. Press the or button to select the hysteresis.
Press the button once to increase by one figure and press it continuously to keep set figure
increased.
Press the button once to decrease by one figure and press it continuously to keep set figure
decreased.
3. Keep pressing the button for 2 seconds or longer after selection is completed.
Then, the setting is finished, and the measurement mode returns.
6. Output type ( )
A desired output mode can be set freely for switch output.
For the operation in normally open and normally closed,
refer to "List of output mode" on page 19.
<How to perform>
1. Keep pressing the button for 2 seconds or longer in the measurement mode.
After [ ] is indicated, press the button five times.
Then, [ ] and current setting appears in turn.
2. Press the or button to select the output type.
3. Keep pressing the button for 2 seconds or longer after selection is completed.
Then, the setting is finished, and the measurement mode returns.

SMC Networks ISE35 Specifications

General

Brand	SMC Networks
Model	ISE35
Category	Switch
Language	English