SMC Networks SMCCO02-Z User Manual

SMCCO02-Z CO Alarm User Guide
Copyright
©
2011 SMC Networks Page 9
All Rights Reserved
I/M SMCWK01-Z rev. 1.0
4/19/11
nt
¾ rm
¾ Move or rotate the CO alarm
tible
ions”).
m
¾
installed on the mounting plate
ble
s”).
Alarm/open condition does not restore
¾ Be sure the CO alarm condition has
cleared at the CO alarm.
¾ Be sure you are using a compatible
control panel (see “Specifications”).
Co rol panel does not respond
Use the 60-401 RF Sniffer to confi
that the CO alarm is sending
messages for activation.
position.
¾ Be sure the CO alarm is enrolled
into the control panel properly.
e sure yo¾ B u are using a compa
control panel (see “Specificat
Ta per condition does not restore
Be sure the CO alarm body is
properly.
¾ Be sure there are no trouble
indications at the CO alarm.
¾ Be sure you are using a compati
control panel (see “Specification
If a tamper alarm occurs
¾ Be sure you are using a compatible
control panel (see “Specifications”).
¾ Be sure the control panel is in
sensor test mode during sensor
testing.
8 Specifications
Compatible panels RB5701-Z
Power Three AA batteries
Battery type 1.5 VDC alkaline
Required batteries Duracell MN 1500, Duracell
MX1500, Energizer E91
Sensor Electrochemical
Sensor life 7 years
Frequency 2.4 GHz
Supervisory interval 27 minutes
Audible alarm Temporal 4
Alarm response times 70 PPM = 60-240 min. 150
PPM = 10-50 min. 400 PPM =
4-15 min.
Dimensions 4.68 x 2.75 x 1.85 in.
(119 x 70 x 47 mm)
Storage temperature -4 to 140°F (-20 to 60°C)
Operating
environment
40 to 100°F (4.4 to 37.8°C)
Relative Humidity 10 to 95% noncondensing

SMC Networks SMCCO02-Z Specifications

General

Brand	SMC Networks
Model	SMCCO02-Z
Category	Carbon Monoxide Alarm
Language	English