C
HAPTER
7
| Performing System Maintenance
Restoring Factory Defaults
– 262 –
RESTORING FACTORY DEFAULTS
Use the Factory Defaults page to restore the original factory settings. Note
that the LAN IP Address, Subnet Mask and Gateway IP Address will be
reset to their factory defaults.
PATH
Maintenance, Restart Device
CLI REFERENCES
"system restore default" on page 275
WEB INTERFACE
To restore factory defaults:
1. Click Maintenance, Factory Defaults.
2. Click Yes.
The factory defaults are immediately restored, which means that no reboot
is necessary.
Figure 135: Factory Defaults
UPGRADING FIRMWARE
Use the Software Upload page to upgrade the switch’s system firmware by
specifying a file provided by SMC/Edge-Core. You can download firmware
files for your switch from the Support section of the SMC/Edge-Core web
site.
PATH
Maintenance, Software Upload
WEB INTERFACE
To upgrade firmware:
1. Click Maintenance, Software Upload.
2. Click the Browse button, and select the firmware file.
To Next Page
Loading...
Need help?
General
