SMC Networks ZFC Series User Manual

- 12 -
Unlocked
Locked
(2)
(3)
(4)
(6)
Lock mechanism
Body
Cover
Product no.
display
Element
Raised part of the
cover
(5)
4. Element Replacement
Replace the element at least once a year or when the following conditions apply.
1) When pressure drop reaches 0.1MPa in a positive pressure or 20kPa in a vacuum pressure.
2) When the set values (flow rate, time required to reach the specified vacuum) change.
Replacement Element Part no.
Part no.
Applicable
filter model
Element size Set description
ZFC-EL-1 ZFC1
φ5 x φ 3 x L11
Spare element: 10 pcs.
ZFC-EL-2 ZFC3
φ6 x φ 4 x L25
ZFC-EL-3 ZFC5
φ12 x φ 8 x L20
ZFC-EL-4 ZFC7
φ 16 x φ 12 x L25
<Element Replacement>
Procedure
(1) Stop the operation and release the pressure in the filter to the atmospheric pressure (return the
vacuum pressure to the atmospheric pressure).
(2) Slide the lock mechanism in the direction of the arrow to release the lock. (The ZFC1 series is not
equipped with a lock mechanism.)
(3) Rotate the cover counterclockwise at least 90 degrees.
(4) Pull out the cover from the body to remove the element. Eliminate the dust stuck to the internal
surface of the body with air blow. (Check that the O-ring is not damaged.)
(5) Mount a new element to the cover and insert it into the body.
(6) Align the raised part of the cover with the model no. display of the body, and push the cover into
the body and rotate it clockwise until it stops.
(7) Set the lock mechanism and check that the cover is locked completely.
(7)

SMC Networks ZFC Series Specifications

General

Brand	SMC Networks
Model	ZFC Series
Category	Water Filtration Systems
Language	English