SMC Networks ZSE20B User Manual

-28-
No.PS※※-OMU0006-A
Function Selection Mode
■Function selection mode
In measurement mode, press the button between 3 and 5 seconds, to display [F 0]. Select to display
the function to be changed [F□□]. Press and hold the button for 2 seconds or longer in function
selection mode to return to measurement mode.
: Some products do not have all the functions. If no function is available or selected due to configuration of other functions, [- - -] is
displayed on the sub display (right).
■Default setting
The default setting is as follows.
If no problem is caused by this setting, keep these settings.
To change a setting, enter function selection mode.
●[F 0] Units selection function Page 30
Units specification
Pressure range
Default setting
"Nil" or M
ISE20B
MPa
ZSE20B(F)
kPa
P
ISE20B
psi
ZSE20B(F)
●[F 1] Setting of OUT1 Page 31
Item
Explanation
Default setting
Output mode
Either hysteresis mode, window comparator mode, error output or
output off can be selected.
Hysteresis mode
Reversed output
Selects which type of switch output is used, normal or reversed.
Normal output
Pressure setting
Sets the ON and OFF point of the switch output.
ISE20B : 0.500 MPa
ZSE20B : -50.5 kPa
ZSE20BF : 50.0 kPa
Hysteresis
Appropriate setting of the hysteresis will prevent the switch output
from chattering.
ISE20B : 0.050 MPa
ZSE20B : 5.1 kPa
ZSE20BF : 5.0 kPa
Delay time
Delay time of the switch output can be selected.
1.5 ms or less
Display color
Selects the output according to the display color.
OUT1 ON : Green
OUT1 OFF: Red

SMC Networks ZSE20B Specifications

General

Brand	SMC Networks
Model	ZSE20B
Category	Switch
Language	English