22
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
FILL WATER TANK WITH
FRESH WATER
Water in the tank
(A12)
is not sucient. Fill the tank with water and/or insert it correctly,
pushing it as far as it will go until it clicks into place.
EMPTY GROUND CONTAINER The grounds container (A4) is full.
Empty the grounds container and drip tray (A14),
clean and then replace them. Important: when re-
moving the drip tray, the grounds container must
always be emptied, even if it contains few grounds. If
this is not done, when you make the next coees, the
grounds container may ll up more than expected
and clog the machine.
INSERT GROUND CONTAINER After cleaning, the grounds container
(A4),
has not been replaced.
Remove the drip tray (A14) and insert the grounds
container.
ADD PREGROUND COFFEE
PREGROUND MAXIMUM
ONE MEASURING CUP
The "pre-ground coee" function has
been selected, but without placing any
pre-ground coee in the funnel
(A21)
.
Place pre-ground coee in the funnel
(g.14)
and
repeat delivery
The funnel
(A21)
for pre-ground coee, is
clogged.
Empty the funnel with the help of the brush (C5) as
described in par. "Cleaning the pre-ground coee
funnel".
To Next Page
Loading...
Need help?
General
