15
Important!
when removing the drip tray,
the grounds container must be emptied, even if it
is not completely full. If this is not done, when
you make the next coffees, the grounds container
may fill up more than expected and clog the ma-
chine.
NOTE 8: Never extract the water tank while the
machine is delivering coffee.
If it is removed, it will not be possible to make
the coffee and the appliance will display
"GROUND TOO FINE ADJUST MILL AND PRESS
OK". To use the appliance again, replace the water
tank, press the OK button (B9). "HOT WATER
PRESS OK" is displayed. Press the OK button
(B9) and deliver water from the cappuccino
maker for a few seconds.
CHANGING THE QUANTITY
OF COFFEE IN THE CUP
The appliance is set by default to automatically
make the following types of coffee:
• Short coffee when the button (B3) is
pressed.
• Standard coffee when the button (B4) is
pressed.
• Long coffee when the button (B5) is
pressed. To change these quantities, proceed
as follows:
• Press the button corresponding to the quan-
tity you want to change ( , or ) for
at least 10 seconds then release until the
message "PROGRAM QUANTITY" is displa-
yed and coffee delivery commences.
• When the coffee in the cup reaches the re-
quired level, press the same button again to
memorise the new amount.
The appliance is now reprogrammed with the
new settings and displays: "READY".
ADJUSTING THE COFFEE
MILL
The coffee mill is preset in the factory to make
coffee correctly and should not require adjusting
initially.
However, if after making the first few coffees you
find that delivery is either too fast or too slow (a
drop at a time), this can be corrected by adjusting
the grinding adjustment knob (fig. A17) (fig. 11).
Important!
The grinding adjustment knob
must only be turned when the coffee mill is in
operation.
For slower delivery and
creamier coffee, turn one
click anticlockwise (finer
pre-ground coffee).
For faster delivery (not a
drop at a time), turn one
click clockwise (coarser
pre-ground coffee).
(Coffee has been used to
factory test the appliance
and it is therefore completely normal for there to
be traces of coffee in the mill.
It is, however, guaranteed to be new.)
MAKING ESPRESSO
COFFEE WITH PRE-
GROUND COFFEE (INSTEAD
OF BEANS)
• Press the button (B7) (fig. 15) to se-
lect the pre-ground coffee function. This di-
sables the coffee mill function.
The appliance now displays the message:
"READY PRE-GROUND".
• Extract the machine by pulling it outwards
using the handles.
• Lift the central lid, place one measure of pre-
ground coffee in the funnel (fig. 16), push the
appliance in then proceed as described in the
chapter "Making coffee using coffee beans".
N.B.: You can make just one coffee at a time
by pressing the (B3), (B4) or (B5)
button once only.
• After using the machine with pre-ground cof-
fee, to go back to making coffee using beans,
To Next Page
Loading...
Need help?
General
