Snap-On ATECH2CS240 User Manual

12
Show Info
Show Info menu selection displays wrench operational information.
1. From Settings menu, press ENTER   button while SHOW INFO selection is highlighted.
2. SHOW INFO screen is displayed.
3. UP   /DOWN   buttons are used to scroll screen.
Operational Information:
 CAL: Date of last wrench calibration.
 ISD: In-Service Date.
 TCF: Torque Calibration Factor.
 ACF: Angle Calibration Factor.
 VER: Software version.
 OVR CNT: Overtorque Counter tracks how many times an over-torque event occurred on
wrench (torque >125% of full scale).
 TQZ: Torque Zero Offset.
 AZZ: Angle Z-Axis Zero Offset.
 AXZ: Angle X-axis Zero Offset.
 Copyright
4. Pressing ENTER   button exits Show Info screen and returns to Settings menu.
Setting Sleep Time
This function will allow user to set interval wrench enters power-down state following last applied
torque or button press.
1. From Settings menu, use UP   /DOWN   buttons to highlight SLEEP TIME selection then press
ENTER   button.
2. SLEEP TIME screen is displayed.
3. Use UP   /DOWN   buttons to select sleep interval.
Selectable Intervals:
 2 MIN (factory default)
 5 MIN
 10 MIN
 30 MIN
 1 HR
 2 HR
 8 HR
4. Press ENTER   button to accept selection and exit to Settings menu.
EXIT
SHOW INFO
SLEEP TIME
SN: 0417500366
CAL: 2017/01/01
ISD: 2017/01/01
ENTER
button
UP/DOWN buttons
AXZ: 157
CAL: 2017/01/01
© 2017 SNAP-ON
ENTER
button

Snap-On ATECH2CS240 Specifications

General

Brand	Snap-On
Model	ATECH2CS240
Category	Power Tool
Language	English