Snap-On TECHANGLE ATECH3F300BN User Manual

12
 Advanced Settings
Accessing Advanced Settings
Advanced settings are accessed from SETTINGS menu selection on main menu.
1. From target torque or angle screen, press and hold ENTER   button for 3 seconds.
2. Highlight SETTINGS menu selection using UP   /DOWN  buttons.
3. Press ENTER   button to display Settings menu.
Menu Selections:
 EXIT - Exits Settings menu and returns to target screen.
 SHOW INFO - Displays wrench operational information.
 SLEEP TIME - Displays power down interval setup screen.
 LCD CONTRAST - Displays LCD contrast setup screen.
 KEY BEEP - Displays button press beep enable/disable setup screen.
 AUTO BACKLIGHT - Displays auto backlight enable/disable screen to turn on backlight during
measurement.
 TOGGLE BACKLGHT - Displays BACKLIGHT button toggle or timeout enable/disable
screen.
 VIBRATOR CONFIG - Displays vibrator ON/OFF configuration for when target reached.
 BATTERY TYPE – Displays the battery type selection screen.
4. To exit Settings menu and return to target torque or angle screen, press ENTER   button while
EXIT menu selection is highlighted.
Note: All user configurable settings are stored in non-volatile memory and are retained while power
is off.
Show Info
Show Info menu selection displays wrench operational information.
1. From Settings menu, press ENTER   button while SHOW INFO selection is highlighted.
2. SHOW INFO screen is displayed.
3. UP   /DOWN   buttons are used to scroll screen.
Operational Information:
 CAL: Date of last wrench calibration.
 ISD: In-Service Date.
 TCF: Torque Calibration Factor.
 ACF: Angle Calibration Factor.
 VER: Software version.
 OVR CNT: Overtorque Counter tracks how many times an over-torque event occurred on
wrench (torque >125% of full scale).
 TQZ: Torque Zero Offset.
 AZZ: Z-Axis Angle Zero Offset.
 AZX: X-Axis Angle Zero Offset.
 AZO+: Gyro Zero Offset at CW full scale torque.
Settings menu
00
100.0
FT-LB
Target Screen
CLEAR DATA
CYCLE COUNT
LANGUAGE
SETTINGSs
UP/DOWN buttons
ENTER
button
EXIT
SET HEAD LENGTH
SHOW DATA
CLEAR DATA
ENTER
button
held
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST

Snap-On TECHANGLE ATECH3F300BN Specifications

General

Brand	Snap-On
Model	TECHANGLE ATECH3F300BN
Category	Power Tool
Language	English