Snapper 16 Series User Manual

Section 2 - OPERATING INSTRUCTIONS
2.2.2. PROPELLING MOWER
(Self Propelled Models Only)
1. Move ground speed control to the desired speed
position. See Figure 2.4.
2. Start engine. Refer to Section "Starting &
Operation".
3. Move wheel drive control against handle to
engage wheel drive and propel mower forward.
Forward speed can be adjusted while the mower is
moving by changing position of the ground speed
control. See Figure 2.4.
RECYCLING MODEL SHOWN
MOVE GROUND
SPEED CONTROL TO (ROPE START MOUNTED ON
RIGHT SIDE OF HANDLE)
DESIRED POSITION
2. Move upper mower handle up or down until the
desired position is achieved.
3. Tighten the lower nuts on each lower handle to
maintain desired position.
WARNING
Stop engine and mower blade by releasing the blade
control before adjusting cutting height.
2.5 CUTTING HEIGHT ADJUSTMENT
1. Pull the height adjusting latch outward and move
to desired cutting height. See Figure 2.6.
! (FAST)
SIXTH SPEED
POSITION
.... _ LOWEST CUTTING
HEIGHT €
)
WHEEL DRIVE
2.3
BLADE -
CONTROL
FIGURE 2.4
STOPPING
Stop engine and blade by releasing the blade
control. Stop forward motion of mower by releasing
the wheel drive control.
H _
........-IGHESTIG I
CUTTING I I
HEIGHT
FIGURE 2.6
2.4 HANDLE HEIGHT ADJUSTMENT
The height of the mower handle can be adjusted as
follows:
1. Loosen the lower nuts on each lower handle as
shown in Figure 2.5.
HIGHER
LOWER
) NUTS ON EACH
LOWERH DLE
!i!
FIGURE 2.5
2. Set all wheels at the same cutting height. The
highest cutting position is Notch 6. The lowest
cutting position is Notch 1. See Figure 2.7.
LATCH
POSITIONS
1
CUTTING HEIGHT SETTINGS
FIGURE 2.7

Snapper 16 Series Specifications

General

Brand	Snapper
Model	16 Series
Category	Lawn Mower
Language	English